How to Jump Start a Chevrolet Traverse

1. Check that the other vehicle has a 12-volt battery with a negative ground system, and park the two vehicles so they do not touch.
2. Set the parking brake firmly and put the shift lever in P (Park) for an automatic transmission.
3. Turn the ignition off and switch off all lights and accessories in both vehicles, except hazard flashers if needed.
4. Check the jumper cables for loose or missing insulation.
5. Connect the red positive (+) cable to the discharged battery positive (+) terminal, then to the good battery positive (+) terminal.
6. Connect the black negative (–) cable to the good battery negative (–) terminal, then to the discharged battery negative (–) grounding point.
7. Start the helping vehicle and let it idle for at least four minutes, then try to start the vehicle with the dead battery.
8. Remove the cables by reversing Steps 6–9 in exact order.

• The discharged battery positive (+) terminal is under a cover on the driver side; open the cover to expose it.
• If the vehicle will not start after a few tries, it probably needs service.
• After starting, let the disabled vehicle idle for several minutes once the cables are removed.

Source: 2026 Chevrolet Traverse owner's manual, PDF pages 312, 313, 314. Steps are summarized in our own words (AI-assisted, checked against the cited pages 2026-10-18). Other model years can differ; your manual has the final word.