How to Reset the Tire Pressure Light (TPMS) on a Chevrolet Equinox EV

1. After rotating the tires or replacing a TPMS sensor, the sensor identification codes must be matched to the new tire/wheel positions.
2. If a tire was just installed, keep the vehicle stationary for about 20 minutes so the system can recalculate.
3. Drive the vehicle at a minimum speed of 20 km/h (12 mph) for the relearn process.
4. Allow up to 10 minutes of driving for the relearn to finish.
5. Check the DIC, where a dash (-) or pressure value will display, and watch for any warning message.

• The TPMS malfunction light and DIC message should go off after the sensor matching process is completed successfully.
• A DIC warning message displays if a problem occurs during the relearn process.

Source: 2026 Chevrolet Equinox EV owner's manual, PDF pages 305, 304. Steps are summarized in our own words (AI-assisted, checked against the cited pages 2026-10-18). Other model years can differ; your manual has the final word.