How to Jump Start a Chevrolet SS

1. Check that the other vehicle has a 12-volt battery with a negative ground system, and park the two vehicles so they do not touch.
2. Set the parking brake firmly and put the shift lever in P (Park), or Neutral with a manual transmission.
3. Turn the ignition to LOCK/OFF and switch off all lights and accessories in both vehicles, except hazard flashers if needed.
4. Connect one end of the red positive (+) cable to the jump start remote positive (+) post (1) of the discharged battery.
5. Connect the other end of the red positive (+) cable to the positive (+) terminal of the good battery.
6. Connect one end of the black negative (–) cable to the negative (–) terminal of the good battery.
7. Connect the other end of the black negative (–) cable to the remote negative (–) post (2).
8. Start the good vehicle and idle it at least four minutes, then try starting the dead vehicle.

• The jump start posts are in the engine compartment on the driver side; remove the red cap to expose the positive terminal.
• To remove the cables, reverse the connection sequence exactly, then let the started vehicle idle for several minutes.
• If the vehicle will not start after a few tries, it probably needs service.

Source: 2017 Chevrolet SS owner's manual, PDF pages 337, 338. Steps are summarized in our own words (AI-assisted, checked against the cited pages 2026-10-18). Other model years can differ; your manual has the final word.