How to Jump Start a Chevrolet Trax

1. Make sure the other vehicle has a 12-volt battery with a negative ground system, and park the two vehicles so they do not touch.
2. Set the parking brake firmly and put the shift lever in P (Park) for an automatic, or Neutral for a manual.
3. Turn the ignition off and switch off all lights and accessories in both vehicles, except hazard flashers if needed.
4. Check the jumper cables for loose or missing insulation.
5. Connect the red positive (+) cable to the discharged battery positive (+) terminal, then to the good battery positive (+) terminal.
6. Connect the black negative (–) cable to the good battery negative (–) terminal, then to the discharged battery negative (–) terminal.
7. Start the good vehicle and let it idle for at least four minutes, then try to start the disabled vehicle.
8. Remove the cables by reversing Steps 6–9 in exact order.

• The discharged battery positive (+) terminal is under a trim cover in the engine compartment on the driver side; open the cover to reach it.
• If the vehicle will not start after a few tries, it probably needs service.
• After starting, let the vehicle idle for several minutes once the cables are removed.

Source: 2026 Chevrolet Trax owner's manual, PDF pages 277, 278, 279. Steps are summarized in our own words (AI-assisted, checked against the cited pages 2026-10-18). Other model years can differ; your manual has the final word.