2008 Toyota Sienna Oil Capacity
2008 Toyota Sienna oil capacity: 6.4 US qt with a filter change (2GR-FE). From the owner's manual, PDF page 558.
6.4US qt
With filter · 2GR-FE · converted from 6.1 L
- Without filter6.0 US qt
2008 Toyota Sienna Owner's Manual, PDF page 558
With filter 6.1 (6.4, 5.4)Open the manual at this page ↗Added Oct 24, 2026 · Updated
See where it's printed
Oil capacity (with filter) · 2GR-FE · PDF page 558
With filter 6.1 (6.4, 5.4)
Oil capacity (without filter) · 2GR-FE · PDF page 558
Without filter 5.7 (6.0, 5.0)
Oil type ILSAC multigrade engine oil Details →
See every quote (2 values)
As printed in the manual
| Applies to | Value | Manual says | Page |
|---|---|---|---|
| 2GR-FE | 6.4 US qtwith filter · converted from 6.1 L | “With filter 6.1 (6.4, 5.4)” | PDF page 558 ↗ |
| 2GR-FE | 6.0 US qtwithout filter · converted from 5.7 L | “Without filter 5.7 (6.0, 5.0)” | PDF page 558 ↗ |
Scroll the table to see the quote and page →
Check the level before you drive
- Park on level ground. Turn off the engine and follow the waiting period in your owner's manual.
- Pull, wipe, and reinsert the dipstick. Use a clean cloth, then push the dipstick all the way back in.
- Read the level between the marks. Pull it out again. The oil should sit between the upper and lower marks.
- Top up a little at a time, then recheck. Use the specified oil. Don't fill above the upper mark.
A quick level check, not a full oil-change guide. Follow your manual's procedure.
Confirm with your own manual, dipstick or door-jamb label.
Report a problem with this page →